Wireless Remote Control - NEC MultiSync ME501 User Manual

Wireless Remote Control

NOTEN:
The buttons with no explanation are not used with
your monitor model.
A
POWER ON and STANDBY Buttons
POWER ON resumes full power from low power mode.
STANDBY puts the monitor in low power mode.
See page 34.
B
INPUT Button
Cycles through the available inputs. See
These are available inputs only, shown as their factory
preset name.
C
OPTION MENU Button
For use when an Option Board is installed. See
The function depends on which Option Board is installed in the monitor.
D
KEYPAD
Press the buttons to set and change passwords, change the
channel and set the REMOTE ID. See
Some buttons are used for CEC (Consumer Electronics
Control) and the Media Player function
Player Menu" on page 40).
page 31.
page 22.
page 50.
("Using the Media
English−24
E
ENT Button
Makes selections in the Media Player settings.
See page 40.
Some buttons are used for CEC (Consumer Electronics
Control).
F
DISPLAY Button
Shows/Hides the information OSD. See
Unlocks the remote control's buttons if they have been
locked in the [LOCK SETTINGS] in the [PROTECT] menu.
Press and hold the DISPLAY button for more than five
seconds to unlock the remote. See
G
MENU Button
Opens and closes the OSD menu. See
H
EXIT Button
Acts as a back button within the OSD to move to the
previous OSD menu.
Acts as an EXIT button to close the OSD menu when on the
main menu.
I
/ Button (up/down button)
Acts as navigation buttons, within the OSD and
Media Player menus, to move the highlighted area up or
down.
J
–/+ Button (minus/plus button)
Acts as navigation buttons, within the OSD and
Media Player menus, to move the highlighted area left or
right.
Increases or decreases the adjustment level within the
selected OSD menu setting.
K
SET/POINT ZOOM Button
SET: When the OSD menu is open, this button acts as a set
button when you make a selection.
L
VOLUME +/– Button
Increases or decreases the audio output level.
M
CH/ZOOM +/– Button*
For use with an Option Board. The function depends on
which Option Board is installed in the monitor.
N
GUIDE Button
For use with an Option Board. The function depends on
which Option Board is installed in the monitor.
page 38.
page 48.
page 38.