Control Panel - NEC MultiSync ME501 User Manual

Control Panel

A
⏻ Button (power button)
Switches between power on and standby. See
B
MUTE Button
Switches the audio mute on/off.
C
INPUT/SET Button
INPUT: Cycles through the available inputs when the OSD
menu is closed.
[DisplayPort], [HDMI1], [HDMI2], [Media Player],
[OPTION]* , [COMPUTE MODULE]*
1
available inputs only, shown as their factory preset
name.
SET: Acts as a set button when making a selection when the
OSD menu is open.
* : This function depends on which Option Board is installed in the monitor.
1
* : This input is available when the optional Raspberry Pi Compute Module
2
Interface Board and Raspberry Pi Compute Module are installed.
See page 73.
D
Increases the audio output level when the OSD menu is
closed.
Acts to move the highlighted area to the right when
navigating through the OSD menu options.
Acts as a plus button to increase the adjustment of an OSD
menu option after it has been selected with the INPUT/SET
button.
E
Decreases the audio output level when the OSD menu is
closed.
Acts to move the highlighted area to the left when navigating
through the OSD menu options.
Acts as a minus button to decrease the adjustment of
an OSD menu option after it has been selected with the
INPUT/SET button.
F
Opens the OSD menu when the OSD menu is closed.
Acts as up button to move the highlighted area up to select
adjustment items within the OSD menu.
G
Opens the OSD menu when the OSD menu is closed.
Acts as down button to move the highlighted area down to
select adjustment items within the OSD menu.
H
Opens the OSD menu when the OSD menu is closed.
page 34.
Acts as a back button within the OSD menu to move to the
previous OSD menu.
Acts as an exit button to close the OSD menu when on the
main menu.
I
Receives the signal from the remote control (when using the
wireless remote control). See
Glows blue when the monitor is in active mode*
. These are
2
Green and Amber blink alternately when the [SCHEDULE
INFORMATION] function is enabled*
When a component failure is detected within the monitor, the
indicator will blink red or blink a combination of red and blue.
Please refer to the Power ON and OFF Modes table on
page
* : If [OFF] is selected in the [POWER INDICATOR] the LED will not glow
1
English−21
+ Button (plus button)
– Button (minus button)
r Button (up button)
s Button (down button)
MENU/EXIT Button
Remote Control Sensor and Power Indicator
34.
when the monitor is in active mode. See
page 35.
1 .
.
1
page 90.