Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch WAN Series
Summary of Contents for Bosch WAN Series
- Page 1 Washing machine WAN... en Instruction Manual and Installation Instructions...
- Page 2 Your new washing machine Note/tip Information about the optimum use of You have chosen a Bosch washing the appliance/any other useful machine. information. Please take a few minutes to read and 1. 2. 3. / a) b) c) become familiar with the advantages of your washing machine.
-
Page 3: Table Of Contents
Contents e n I n s t r u c t i o n M a n u a l a n d I n s t a l l a t i o n I n s t r u c t i o n s Intended use. -
Page 4: Intended Use
Intended use Drum ......34 Intended use Descaling..... 34 Detergent drawer and housing . -
Page 5: Safety Instructions
Safety instructions Do not allow children to Safety instructions ■ clean or maintain this appliance unsupervised. The following safety information Keep children under 3 years S a f e t y i n s t r u c t i o n s and warnings are provided to ■... -
Page 6: Installation
Safety instructions Keep packaging, plastic film dangerous situation. Make sure and packing components away that: from children. The mains voltage on your ■ power socket matches the Warning rated voltage specified on Risk of poisoning! the appliance (identification Detergents and care products plate). - Page 7 Safety instructions circuiting or fire due to If you take hold of any of the ■ overheating. appliance's protruding parts The mains cable must not be (e.g. the appliance door) in kinked, crushed or altered, and order to lift or move it, these must not come into contact with parts may break off and any heat sources.
-
Page 8: Operation
Safety instructions The appliance is secured for Caution! ■ transportation by transport Material damage/damage to locking devices. If the the appliance transport locking devices are If the water pressure is too ■ not removed before the high or too low, the appliance is operated, this appliance may not be able to may result in damage to the... - Page 9 Safety instructions Do not use cleaning agents that drawer is opened while the contain solvents. appliance is in operation. Rinse eyes/skin thoroughly if Warning they/it come(s) into contact Risk of injury! with detergents or care If you support your weight/sit products.
-
Page 10: Cleaning/Maintenance
Safety instructions Do not use cleaning agents that Cleaning/Maintenance contain solvents. Warning Warning Danger of death! Risk of electric shock/material The appliance is powered by damage/damage to the electricity. There is a risk of appliance! electric shock if you come into If moisture penetrates the contact with live components. -
Page 11: Environmental Protection
Environmental protection Clean the appliance with The temperatures which can be ■ ■ selected refer to the care labels on nothing but water and a soft, the textiles. The temperatures used damp cloth. in the machine may deviate from this Remove any detergent, to ensure you get the optimum ■... -
Page 12: Safety Instructions
Positioning and connecting Standard ( Mains cable ■ 0 Water drain hose with elbow 8 Water supply hose on Aqua- Secure model @ Water supply hose on Aqua-Stop model H Bag: Operating and installation ■ instructions + supplementary sheet for the operating and installation instructions After-sales service location ■... -
Page 13: Installation Surface
Positioning and connecting If the washing machine is lifted by its Installation on a base or a ■ protruding parts (e.g. the washing wooden joist floor machine door), the components may break off and cause injuries. Caution! Do not lift the washing machine by Damage to the appliance protruding parts. -
Page 14: Removing The Transport Locks
Positioning and connecting Removing the transport locks Caution! Damage to the appliance The machine is secured for ■ transportation using transport locks. If the transport locks are not removed, the machine may become Fit the covers. Lock the covers firmly damaged when it is operated. -
Page 15: Water Inlet
Positioning and connecting The following are available from Tip: specialist retailers/our after-sales service: Extension for Aqua-Stop and cold ■ water supply hose (approx. 2.50 m); order no. WMZ 2380, WZ 10130, Z 7070X0 A longer supply hose (approx. 2.20 ■ m) for standard models;... -
Page 16: Water Outlet
Positioning and connecting Model: Aqua-Stop Caution! ■ Damage to the appliance/fabrics If the end of the drain hose is immersed in the drained water, water may be sucked back into the appliance and may damage the appliance/fabrics. Make sure that: –... -
Page 17: Electrical Connection
Positioning and connecting All four appliance feet must stand The mains cable is only replaced by ■ firmly on the ground. a qualified electrician (if this is Tighten the lock nut against the necessary). Replacement mains housing. cables are available from the after- In doing so, hold the foot tight and sales service. -
Page 18: Transportation
Positioning and connecting Pour approximately 1 litre of water Clip the mains cable securely in the into compartment II. holders. Insert and tighten the Pour standard detergent into screws. compartment II. To prevent foaming, only use Note: half the amount of detergent recommended by the detergent manufacturer. -
Page 19: Getting To Know The Appliance
Getting to know the appliance Getting to know the appliance Washing machine G e t t i n g t o k n o w t h e a p p l i a n c e Detergent drawer Operating/display panel Loading door with door handle Service flap... -
Page 20: Control Panel
Getting to know the appliance Control panel Control panel differs depending on the model 8 Display panel for settings and ( Programmes ~ Supplementary information sheet for the operating and installation instructions. 0 Programme selector The buttons are sensitive, so they Note: only need to be touched gently. - Page 21 Getting to know the appliance More information on the display panel Button Display in- Description Display in- Description dicator dicator Selectable Tempera- ‰** kg Load recommendation ture Programme progress: - - - Š‹ °C In °C; - - = cold Washing Selectable Spin speed Rinse...
-
Page 22: Laundry
Laundry Check for metal items (paper clips, Display in- Description ■ etc.) and remove them. dicator Wash delicates in a laundry bag ■ “: - - Fault display (tights, underwired bras, etc.). ~ "Information on the display panel" on page 38 ‹... -
Page 23: Starching
Laundry – Stains: Remove/pretreat stains Dyeing/bleaching while they are fresh. Firstly, dab Dye should only be used in normal with soapy water; do not rub. household quantities. Salt may damage Then wash the items of laundry stainless steel. Always follow the dye with the appropriate programme. -
Page 24: Detergent
Detergent Saving energy and detergent Detergent For light and normal soiling, you can C orrect selection of detergent save energy (lower washing D e t e r g e n t temperature) and detergent. The care label is crucial for selecting the correct detergent, temperature and Saving Soiling/note... -
Page 25: Programme Default Settings
Programme default settings Spin speed Programme default (0, Centrif., Velocidad de centrifugado, settings Rotação de centrifugação) Depending on what stage the The programme default settings for all P r o g r a m m e d e f a u l t s e t t i n g s programmes are preset at the factory programme is in, you can change the spin speed (in rpm;... -
Page 26: Additional Programme Settings26
Additional programme settings The door will be locked. Additional programme The selected number of hours (e.g. ‰ h) is shown in the display panel settings and counts down until the wash programme starts. The duration of The available settings vary depending the programme is then displayed. -
Page 27: Water Plus/Rinse Plus
Operating the appliance Water Plus/Rinse Plus Operating the (à,Z, Agua+/aclarado+, Extra appliance Aclarado, Agua Extra, água+/ enxaguamento+, Água extra, Enxag. Preparing the washing adicional, água+, enxaguamento+) O p e r a t i n g t h e a p p l i a n c e machine Setting depending on the model Notes... -
Page 28: Changing The Programme Default Settings
Operating the appliance Spin speed, Placing laundry into the drum ■ The maximum load and the duration ■ of the programme (alternately) Warning Risk of death! Changing the programme Items of laundry pretreated with cleaning agents that contain solvents, default settings e.g. -
Page 29: Measuring And Adding Detergent And Care Products
Operating the appliance Measuring and adding detergent and care products Caution! Damage to the appliance Cleaning agents and agents for pre- treating laundry (e.g. stain removers, prewash sprays, etc.) may cause Measuring aid A* For liquid detergent damage if they come into contact with Compartment II Detergent for the the surfaces of the washing machine. -
Page 30: Starting The Programme
Operating the appliance three seconds. The E symbol appears For models without a measuring aid, pour the liquid detergent into the in the display panel. appropriate dispenser and place it in E lights up: The childproof lock is ■ the drum. active. -
Page 31: Changing The Programme
Operating the appliance Press the Inicio/Pausa A (Start/ Pressing the Inicio/Pausa A (Start/ ■ Reload) button to continue the Reload) button (the laundry will be programme. spun with the default spin speed If the è symbol lights up in the setting ) or ■... -
Page 32: Sensors
Sensors on page 37 Appliance settings Wipe the rubber seal and the You can change the following settings: ■ washing machine door dry. A p p l i a n c e s e t t i n g s The volume of the information Leave the door and detergent ■... -
Page 33: Cleaning And Maintenance
Cleaning and maintenance To change the volume of the button ■ Cleaning and signals, rotate the programme selector to position 3. Use the maintenance Ready in button again to change the volume. Warning C l e a n i n g a n d m a i n t e n a n c e Risk of death! ‹... -
Page 34: Machine Housing/Control Panel
Cleaning and maintenance Machine housing/control Remove the insert. a) Push the insert upwards from panel below with your finger. Wipe the housing and the control ■ panel with a soft, damp cloth. Remove the detergent residue ■ immediately. Do not clean with a water jet. ■... -
Page 35: Drain Pump Is Blocked
Cleaning and maintenance b) If the measuring aid* for liquid Take the drain hose out of the detergent is used, slide it retainer. forwards, fold down and click into Remove the sealing cap and allow place. the water to flow out into a suitable container. -
Page 36: Drain Hose At The Siphon Is Blocked
Cleaning and maintenance To prevent unused detergent Press the Inicio/Pausa A (Start/ Note: from flowing straight into the drain Reload) button. Allow the during the next wash, pour 1 litre of programme to run for approximately water (without detergent) into 40 seconds. -
Page 37: Faults And What To Do About Them
Faults and what to do about them Faults and what to do about them Emergency release F a u l t s a n d w h a t t o d o a b o u t t h e m e.g. -
Page 38: Information On The Display Panel
Faults and what to do about them Information on the display panel Display Cause/remedy è lights up The temperature is too high. Wait until the temperature drops. ■ The water level is too high. It is not possible to add laundry. Close the door ■... -
Page 39: Faults And What To Do About Them
Faults and what to do about them Faults and what to do about them. Faults Cause/Remedy Water is leaking from the Attach the drain hose correctly or replace it. ■ appliance. Tighten the screw connection of the drain hose. ■ The machine is not filling Have you pressed the Inicio/Pausa A (Start/Reload) button? ■... - Page 40 Faults and what to do about them Faults Cause/Remedy Residual water in the Not a fault – the effect of the care product is not impaired. ■ care-product compart- Clean the insert if necessary. ■ ment i. Odours or greasy depos- Depending on the model, run the Limpieza/Limpeza tambor (Drum Clean)* its in the washing or Algodón/Algodão (Cottons) 90 °C programme without laundry.
-
Page 41: After-Sales Service
After-sales service After-sales service Technical data If you cannot rectify a fault yourself, Dimensions: A f t e r - s a l e s s e r v i c e T e c h n i c a l d a t a please contact our after-sales service. -
Page 42: Aqua-Stop Warranty
Aqua-Stop warranty Aqua-Stop warranty Only for appliances with Aqua-Stop A q u a - S t o p w a r r a n t y In addition to warranty claims against the vendor based on the purchase agreement and to our appliance warranty, we will provide compensation under the following conditions: If water damage is caused due to a... - Page 44 0344 892 8979 (Calls charged at local or mobile rate.) 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.) You can find the contact information for all countries in the attached after-sales service directory. Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München, GERMANY *9001181715*...