Table of Contents
Advertisement
Control panel model 2
Explanation
Fan on/off
#
Automatic mode
>
1-3
Fan settings
Intensive setting 1
C
Intensive setting 2
D
Fan run-on
%
Metal grease filter saturation indicator
E
Activated charcoal filter saturation indicator
F
Light on/off/dimming
B
Setting the fan
Switching on
Pull out the filter pull-out and touch the
■
The fan will start at setting 2.
Select the fan settings.
■
When the filter pull-out is pushed in, only fan
Note:
settings 1, 2 and 3 can be selected.
Switching off
Touch the
symbol. Slide in the filter pull-out.
%
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the
or
C
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the symbol for the required fan setting.
Fan run-on time
Touch the
symbol or slide in the filter pull-out while
y
the extractor hood is operating.
After approximately 10 minutes, the fan will switch off
automatically.
symbol.
%
symbol.
D
Automatic mode
Switching on
Touch the
symbol.
#
■
The fan starts at setting 2.
Touch the
symbol.
>
■
The optimum fan setting 1, 2 or 3 is automatically
set via a sensor.
Switching off
Touch
or any fan setting to switch off automatic
#
mode.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
Automatic mode can run for a maximum of four hours.
Sensor control
In automatic mode, a sensor on the extractor hood
detects the intensity of the kitchen steam. Depending
on the sensor setting, the extractor hood automatically
switches to another fan setting.
Default setting: Setting
Lowest setting: Setting
Highest setting: Setting
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
Press and hold the
>
1.
the fan is switched off. The setting is displayed.
The sensor control setting can be changed by
2.
touching symbol 1, 2, 3, or the
symbol.
To confirm the entries, press and hold the
3.
for four seconds.
Operating the appliance en
(fan setting 3)
„
(fan setting 1)
‚
†
(fan setting
D
)
symbol for four seconds when
or
C
>
D
symbol
7
Advertisement
Table of Contents
