Spring - Bosch JLR-100-069 Original Instructions Manual

en-gb | 44 | JLR-100-069
5. There are two M5 screws on both the top and
bottom of each long side (33) of the scissors lift
table. Loosen all eight M5 screws and set them
aside.
Figure 55: Opening the Protective Bellows
3 Platform (static)
4 Platform (extendible)
5 Protective Bellows
33 Long Side
34 Snaps (8 pieces per long side)
6. Undo the snaps (34).
7. Twist the protective bellows (5) by 90°.
8. Push the long side of the protective bellows (5)
over the short side of the static platform (3) to
the centre of the scissors element. Pull up the
protective bellows (5) and remove it from the
scissors lift table. Dispose of the protective
bellows (5).
9. Perform the last step in reverse order to attach
the new protective bellows (5) to the scissors lift
table.
10. Secure the protective bellows (5) with the M5
screws on the scissors lift table. Tighten all eight
M5 screws by hand.
Close the snaps (34).
SP04006297 | 06/2021
6.11

Spring

Figure 56: Scissors Element
1 Handle
17 Mechanical Lock
18 Locking Block
The protective bellows need to be opened for certain
maintenance work and to replace certain parts on the
scissors lift table.
CAUTION
Crushing Hazard in the Scissors Element!
Hands or fingers could be crushed when raising or
lowering the platforms.
Open the protective bellows only when there are
no loads on the platforms.
Open the protective bellows only for the
maintenance work specified in these instructions.
Use the scissors lift table only with the protective
bellows in place.
Only qualified personnel may open the protective
bellows.
Keep hands and feet out of the scissors element.
Close the protective bellows after the maintenance
work has been completed.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany