Download Print this page

Toro 108-1381 Installation Instructions

Ce kit

Advertisement

Quick Links

CE Kit
for 72in Side Discharge Mower for Groundsmaster
Traction Units
Model No. 108-1381
Install the following decal and guards on the
Groundsmaster 72 inch side discharge deck. Use the
location description listed below to determine the
correct placement on the product. Before installing the
Important: Should the decal or the guards become damaged or illegible, replace them immediately.
Each part number is listed below and also on each decal. Replacements may be ordered through your
authorized Toro distributor.
Insert the following Location Table into the Operator's Manual for the owner's reference.
English Parts Description
Danger Decal
Baffle–RH
Baffle–LH
Bolt
Outer Guard Assembly
Inner Guard Assembly
Retaining Ring
Nylon Bushing
CE—Certificate of Compliance
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Location
On Deflector
Under RH Front of Deck
Under LH Front of Deck
RH & LH Deck Covers
Drive Shaft
Drive Shaft
Inner & Outer Guard Assembly
Inner & Outer Guard Assembly
Loose Parts Bag
Register at www.Toro.com.
decal, remove or thoroughly clean the English decal,
and apply the appropriate translated language version in
its place (or over it).
English Part No.
43-8480
Form No. 3351-941 Rev A
®
300 Series
Installation Instructions
European Part No.
106-6753
93-6604-01
93-6605-01
323-7
93-9985
93-9965
115-4546
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Qty.
1
1
1
2
1
1
2
2
1

Advertisement

loading

Summary of Contents for Toro 108-1381

  • Page 1 72in Side Discharge Mower for Groundsmaster ® 300 Series Traction Units Model No. 108-1381 Installation Instructions Install the following decal and guards on the decal, remove or thoroughly clean the English decal, Groundsmaster 72 inch side discharge deck. Use the...
  • Page 2 Installing the Baffles Note: Make sure the baffles are level and not bent. A bent baffle could affect the quality of cut. 1. Using the dimensions shown in Figure 1, locate, mark, and drill 7 holes (0.344 inch (9mm) dia.) in the front of the deck.
  • Page 3 Use the chart below to determine the combinations of weight required. Order parts from your local Authorized Toro Distributor. Four Wheel Drive Groundsmaster 300 Series Traction Units do not need additional rear weight to comply with CE Standards.