Groomer Pull Link Kit
for Serial Number 401499999 and Before Greensmaster
3150 Series Traction Units
Model No. 106-2643
This product contains a chemical or chemicals known to the State of California
Determine the left and right sides of the machine from
the normal operating position.
1.
Park the machine on a level surface, lower the
cutting units, shut off the engine, set the parking
brake, remove the ignition key, and disconnect
the spark plug.
2.
Remove the roller, spring washers, pull link
assemblies, flat washers, lockwashers, and
grease screws from the pull frame
1. Roller
2. Spring washer
3. Pull link assembly
4. Pull frame
5. Flat washer
3.
Remove and retain the ball joint receivers from
the pull link assemblies
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
(Figure
Figure 1
6. Lock washer
7. Grease screw
8. Jam nut
9. Ball joint receiver
(Figure
1). Discard all
Register at www.Toro.com.
WARNING
CALIFORNIA
of the previously removed hardware except the
roller and ball joint receivers.
4.
If the pull frame does not have 2 holes in the
underside, drill them at the location shown in
Figure 2
1).
1. 49.4 cm (19-7/16 inches)
2. 8.8 cm (3-1/2 inches)
5.
Secure 2 bumpers to the underside of the pull
frame using 2 self tapping screws
g245908
Form No. 3421-593 Rev A
Installation Instructions
using a 0.221 inch drill bit.
Figure 2
3. 1.9 cm (3/4 inch)
Original Instructions (EN)
All Rights Reserved *3421-593* A
Printed in the USA
®
3120 or
g245919
(Figure
3).