Connecting The Projector; Connecting A Computer - Sony VPL-SW125 Operating Instructions Manual

B Preparation

Connecting the Projector

Notes
• Make sure all the equipment is powered off when connecting the projector.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or
cause a malfunction. When pulling out a cable, be sure to grip it by the plug, not the cable itself.
• For more information, refer also to the instruction manuals of the equipment you are connecting.
• Use a no-resistance audio cable.

Connecting a Computer

Connection with a computer is explained for each input signal.
INPUT A/INPUT B (INPUT B is available only for VPL-SX125)
For connecting a computer with an RGB output connector.
Computer
Note
It is recommended that you set the resolution of your computer to 1024 × 768 pixels (VPL-SX125)
or 1280 × 800 pixels (VPL-SW125) for the external monitor.
Mini D-sub 15-pin cable (supplied)
RGB output
connector
Audio output
connector
Audio cable (Stereo mini plug) (not supplied)
Connecting the Projector
7