Using Network Features; Displaying The Control Window Of The Projector With A Web Browser - Sony VPL-SW125 Operating Instructions Manual

B Network

Using Network Features

Connection to the network allows you to operate the following features:
• Checking the current status of the projector via a Web browser.
• Remotely controlling the projector via a Web browser.
• Receiving the e-mail report for the projector.
• Making the network settings for the projector.
• Supports network monitoring, control protocol (Advertisement, PJ Talk, PJ Link, AMX
DDDP [Dynamic Device Discovery Protocol]).
Notes
• The menu displays used for the explanation below may be different depending on the model you
are using.
• Supported Web browsers are Internet Explorer 6/7/8.
• The menu displays only English.
• If the browser of your computer is set to [Use a proxy server] when you have access to the projector
from your computer, click the check mark to set accessing without using a proxy server.
Displaying the Control Window of the Projector with a Web
Browser
1
Connect the LAN cable.
LAN cable
(straight type)
(not supplied)
LAN Connector
Hub, router, etc
2
Set the network settings for the
projector using "Network Setting" on
the SET SETTING menu (page 21).
3
Start a web browser on the computer,
enter the following in the address field,
then press the Enter key on your
computer.
http://xxx.xxx.xxx.xxx
(xxx.xxx.xxx.xxx: IP address for the
projector)
You can confirm the IP address of the
projector under "Network Setting" on
the SET SETTING menu.
The following window appears in the
Web browser:
Once you make the network settings, you
can open the Control window only by
performing step 3 of this procedure.
How to operate the Control window
Switching the page
Click one of the Page Switching buttons to
display the desired setting page.
Page Switching buttons
Using Network Features
27