Dell PowerVault 124T LTO-3 User Manual page 55

TapeAlert Log Entry:
0000000000000800
Drive TAflag[54] No Start Of The start of data could not be found on the
Data tape.
TapeAlert Log Entry:
0000000000000400
Drive TAflag[55] Loading The operation has failed because the media
Failure cannot be loaded and threaded.
TapeAlert Log Entry:
0000000000000200
Drive TAflag[56] The operation has failed because the
Unrecoverable Unload medium cannot be unloaded.
Failure
TapeAlert Log Entry:
0000000000000100
Drive TAflag[57] Automation The tape drive has a problem with the
Interface Failure automation interface.
TapeAlert Log Entry:
0000000000000080
Drive TAflag[58] Firmware The tape drive has reset itself due to a
Failure detected firmware fault.
TapeAlert Log Entry:
0000000000000040
Drive TAflag[59] WORM The tape drive has detected an
Medium - Integrity Check inconsistency during the WORM medium
Failed integrity checks.
TapeAlert Log Entry:
0000000000000020
Drive TAflag[60] WORM An attempt had been made to overwrite
Medium - Overwrite user data on WORM medium.
Attempted
TapeAlert Log Entry:
0000000000000010
Returning the Autoloader for Service
If you need to return the autoloader or a component of the autoloader for service, contact support.dell.com. The following steps will help you to prepare the
autoloader for shipment, remove the autoloader from a rack, and package the autoloader.
To prepare the autoloader for shipment
1. Remove all cartridges from the unit.
2. Power off the autoloader through the front panel.
3. Remove the power, Ethernet, and SCSI cables, and any terminators from the autoloader.
NOTE: Do not ship these items if you are returning the autoloader.
To Remove the Autoloader from a Rack
1. Loosen the two thumb screws that secure the loader to the front of the rack.
2. Using two people, or an appropriately rated mechanical lift, remove the autoloader from the rack by sliding the autoloader out and supporting it from the
bottom.
3. Place the autoloader into the original packaging box, or the packaging from the replacement unit.
Tape damaged, bulk erased, or
incorrect format.
The drive is unable to load the
media and thread the tape.
The drive is unable to unload the
medium.
The drive has identified an
interface fault.
Firmware issue encountered.
WORM cartridge may have been
tampered with.
The application software does
not recognize the medium as
WORM.
Get other manuals https://www.bkmanuals.com
Check that you are using the correct
l
format tape.
Discard the tape or return the tape to
l
your supplier.
Remove the cartridge, inspect it as specified
in the product manual, and retry the
operation.
Remove the cartridge if possible, inspect it as
specified in the product manual, and retry the
operation.
Check the power to the automation
l
system.
Check the cables and cable
l
connections.
Replace WORM medium.
If a WORM medium was used
l
inadvertently, replace it with a normal
data medium.
If a WORM medium was used
l
intentionally:
- check that the software application is
compatible with the WORM medium
format you are using.
- check that the medium is bar-coded
correctly for WORM.