FASTENING THE INSTALLATION BRACKETS
•
Each cooker top is provided with an installation kit including brackets and screws for
fastening the top to fixture panels from 2 to 4 cm thick.
Turn the cooker top upside down and fasten the brackets "F and R" to the appropriate
•
socket holes, without tightening the screws "B" for the moment.
•
Make sure that the brackets are fastened as shown in the figures.
FASTENING THE COOKER TOP
•
Insert the cooker top into the hole and position it correctly.
•
Adjust the position of the brackets "F and R"; tooth "C" of the tabs should go into the
hole. Tighten screws "B" to block the cooker top firmly in position.
•
With a sharp cutter or trimmer knife trim the excess sealing material around the edge
of the cooker top. Take care not to damage the benchtop.
Rear side
seal C
seal A
Fig. 4.7
16
C
B
R
Fig. 4.5
R
(figs. 4.5, 4.6, 4.7)
(figs. 4.5, 4.6, 4.7)
Front side
C
Fig. 4.6
R
F
seal A
B
F
F