MacDon R216 Unloading And Assembly Instructions page 30

1. Remove shipping wire (A) securing hose ends (B) to secured
hoses (C), and remove all packing foam from the hose ends.
2. Remove all packing foam from hose support (D).
NOTE:
The packing foam is not shown in the illustration.
3. Remove shipping wire cross ties (A) securing hoses (B) to
center-link (C) near shipping stands (D), and pull the hoses
out from under the center-link.
4. Remove shipping wire (E) from center-link (C) and move
hoses (B) away from the center-link. Rest hoses (B) on top
of the header.
5. M1240 and M2260 Windrower: Remove the shipping wire
and the packing foam, and remove coiled electrical
harness (A) from center-link (B). Place the harness in a safe
spot until it is time to install the harness on the windrower.
6. M205 SP Windrower: Remove the shipping wire and
remove coiled electrical harness (A) from center-link (B).
NOTE:
The harness for the M205 SP Windrower is included in a
separate M205 Windrower Compatibility Kit (B7220).
262271
ASSEMBLING HEADER
Figure 4.7: Hydraulic Hose Bundle in Shipping Position
Figure 4.8: Hydraulic Hose Bundle in Shipping Position
Figure 4.9: Center-Link
20
A
B
Revision A