MacDon R216 Unloading And Assembly Instructions page 23

6. Using a forklift, position shipping platform (A) at the
container opening. Ensure that the platform lines up with
the container floor.
7. Attach a chain or equivalent device (B) secured to the
outboard shipping stand to a second forklift that will pull
header (C) out of the shipping container.
NOTE:
The actual shipping stand may be different than the one
pictured.
8. Slowly pull the header straight out of the shipping
container and onto the shipping platform. Ensure that the
center anchor beam is clear from the other header.
9. If the platform is resting on the container floor, lift the
platform slightly to take weight off the container.
10. Raise the trailer storage stands and remove the blocks from
the trailer wheels.
11. Slowly and carefully drive the trailer with the container
away from the platform, observing all clearances.
12. When the container is clear of the platform, slowly lower
the platform and the header to the ground.
13. Remove the chain from the shipping stand.
NOTE:
The actual shipping stand may be different from the one
pictured.
14. Back the forklift away from the platform and the header.
15. Approach the header from its underside and slide the forks
into fork straps (A) on the bottom crossmember of the
shipping stand.
16. Take the header to the storage or setup area.
17. Set the header down on secure, level ground.
Do NOT lower the header into working position.
18. Check the header for any shipping damage or missing parts.
19. Repeat Step 1, page 12
remaining headers in the shipping container.
262271
UNLOADING HEADER FROM SHIPPING CONTAINER – EXPORT
to Step 18, page 13 for the
C
B
A
Figure 3.5: Rotary Disc Header in Container
Figure 3.6: Rotary Disc Header in Container
Figure 3.7: Moving Disc Header with Forklift
13
Revision A