Dewalt DW7451 - Heavy-Duty Table Saw Stand Manual

Introduction

To reduce the risk of serious personal injury, read the table saw instruction manual before using any accessory. Failure to heed these warnings may result in personal injury and serious damage to the table saw and the accessory. When servicing this tool, use only identical replacement parts.

• This table saw stand is designed only for use with the DW745, DWE7480 and DCS7485 table saws. Do not use this stand with any other tool.
• Do NOT mount the table saw to the stand in any other orientation.
• Position all of the feet in the same orientation or unstable footing may occur.
• Do not climb on or sit on saw stand.
• Do not use saw stand on inclined, uneven or unstable surfaces.
• Do not use saw stand if it is damaged or bent.
• The back legs of the saw stand are slightly longer than the front legs to provide additional support. Use the saw stand and operate the table saw from the front side only.
• Maximum load: 150 lbs. (68.1 kg.)
  SAVE THESE INSTRUCTIONS

Assembly

• Assemble as shown in Figure A.
  

To Open the Table Saw Stand

1. Unfold the saw stand until it is fully opened. Place it upright, as shown in Figure B.
   
2. Place the table saw on the stand. Place the front bar of the saw into the lip on the front of the stand (Fig. C).
   
3. Lower the rear feet of the saw onto the ledgeat the back of the stand as shown in Figure C.
4. Secure the rear of the saw with the bolts provided (Fig. D). Be sure the saw does not rock or wobble in place.
   

To Close the Stand

1. Remove the bolts from the rear rail of the saw.
2. Tilt the rear of the saw up allowing the rear feet to clear the lip on the back of the stand.
3. Pull the saw forward and up allowing the front bar to slide out of the lip on the stand.
4. After stowing the saw, pick the stand up by both rails and close it by squeezing the top rails toward each other.