Frost And/Or Condensation Occurs; The Lamp On The Control Panel Blinks - Hitachi R-HW530NV Instruction Manual

TROUBLESHOOTING
When this happens
There is frost,
condensation, or ice
on the inside of the
refrigerator or slide
door frame.
Condensation
adheres to the
outside of the
refrigerator.
There is condensation on
the back of the refrigerator
and the walls.
There is condensation
inside the Refrigerator
Compartment.
3 or more temperature
control lamps for energy
saving/freezer/fridge are
blinking.
"On" indicator
lamp blinking or
" / " and " "
are blinking
The Ice Maker "Quick",
"On", and "Off" indicator
lamps blink simultaneously.
All the indicator
lamps are blinking.
The lit lamps
are changing
continuously.
76
Check Item
Was one the Refrigerator Compartment doors
or slide doors temporarily left partially open?
Did you open one of the doors for a long time
or did you open and close it too frequently?
Is the air surrounding the refrigerator
humid?
Is the temperature set to "
Is the humidity around the refrigerator too high or
is the gap between the back of the refrigerator and
the wall too narrow?
Did you open one of the doors for a long time
or did you open and close it too frequently?
For energy saving/freezer/fridge, check
each of the seven lamps "
see if they are blinking or off.
Did you place food or ice other than ice made by
the automatic ice maker in the Ice Compartment?
Did you touch and hold
or longer?
Is one of the doors open?
Is food or another item stuck in a door so that
it cannot close completely?
( Continued )
When closing slide doors and doors, make sure that no
food or bags are caught, and close them properly.
When a door is opened or closed, water in the air may cling to the
walls or parts in the Freezer in the form of frost or ice. Open and
close the doors quickly, or reduce the frequency of opening and
closing the doors. Wipe off any frost or condensation with a dry cloth.
Condensation may adhere to these parts when the indoor humidity is
high (ex: rainy day). Wipe off the condensation with a dry cloth.
When the temperature is set to "
"?
formed on the surface of the doors. Set the temperature to "
Wipe off the condensation with a dry cloth.
Keep the back of the refrigerator at least 2 cm away from the wall.
Condensation may form on the walls and/or around
the Cold Air Blowout Port when the doors are opened
and closed frequently or when the humidity is high
around the refrigerator. It does not indicate any fault.
Wipe off the condensation with a dry cloth.
Place a mark on which lamps are
blinking and contact a Hitachi customer
/ / " to service center for repair.
If you record the information, the problem
will be communicated accurately.
Food, etc. may be touching the ice tray.
Empty the Ice Compartment and perform "Ice Maker Cleaning".
Ice Maker Cleaning is in progress. The indicator lamps will
for 5 seconds
stop blinking in about 4 minutes. Do not open any of the
refrigerator doors while the indicator lamps are blinking.
Close any doors that are open.
If food or another item is stuck in a door, remove it and
close the door completely.
The refrigerator is in Store mode Cancel this mode.
The refrigerator does not cool in Store mode.
Open the Refrigerator Compartment doors (left and right)
and the Freezer Compartment lower door.
Touch on the Control Panel to light up the display.
Touch and hold
All the indicator lamps light for a few seconds, Store mode
is released, and cooling operation starts.
Close the Refrigerator Compartment doors (left and right)
and the Freezer Compartment lower door.
Action and Reasons
", condensation may be
(Checklist)
Pg. 80
for 10 seconds or longer until you hear two short beeps.
".
Pg. 53
Pg. 48
Condensation
Pg. 71