Assembly Procedures - Philips EasyKey 1000 Series User Manual

Assembly procedures

The following assembly instructions are for right-hand swing doors. For left-hand
swing doors, please read and understand the 'Notice before assembling' section,
and follow the 'Adjustable latch instructions' to adjust the latch bolt direction
accordingly.
Drill holes according to the drilling
1
template, then place the mortise
inside the frame and use the two
anchor screws to secure the mortise.
Attention
During installation, the deadbolt should not
be protruding or extending out.
Place the interior unit base firmly
3
against the inside of the door and
secure it with two screws. Similarly,
align the base of the interior lock
cylinder cover base against the inside
of the door and secure it with two
screws.
6
Align the hollow square shaft on the
2
exterior unit with the rotating opening
on the mortise. Align the exterior lock
cylinder cover with the lock cylinder,
ensuring that the exterior unit and the
exterior lock cylinder cover are tightly
attached to the outside of the door.
Refer to the diagram for instructions
4
on opening the battery cover.
Push the cover as
indicated by arrow