ALDI HM80L User Manual page 11

HM80L
Safe work
3
Only use saw blades for which the maximum permissible speed is not lower
–
than the maximum spindle speed of mitre saws and which are suitable for
the material to be cut.
Make sure that the saw blade does not touch the turntable in any position by
–
pulling out the mains plug and rotating the saw blade by hand in the 45° and
90° position. If necessary, readjust the saw head.
When transporting the electric tool, only use the transport devices. Never
–
use the protective devices for handling or transport.
Make sure that the lower part of the saw blade is covered during transport,
–
e.g. by the protective device.
Be sure to only use spacers and spindle rings specified by the manufacturer
–
as suitable for the intended purpose.
The floor around the machine must be level, clean and free of loose parti-
–
cles, such as chips and cutting residues.
Do not remove any cutting residues or other parts of workpieces from the
–
cutting zone while the machine is running and the saw unit is not at rest.
Make sure that the machine is always secured on a workbench or a table if
–
at all possible.
Support long workpieces (e.g. with a roller table) to prevent them sagging at
–
the end of a cut.
Warning! This electric tool generates an electromagnetic field during operation.
This field can impair active or passive medical implants under certain conditions. In
order to prevent the risk of serious or deadly injuries, we recommend that persons
with medical implants consult with their physician and the manufacturer of the medi-
cal implant prior to operating the electric tool.
SAFETY INSTRUCTIONS FOR THE HANDLING OF SAW BLADES
Only use insertion tools if you have mastered their use.
1
Observe the maximum speed. The maximum speed specified on the insertion
2
tool may not be exceeded. If specified, observe the speed range.
Observe the motor / saw blade direction of rotation.
3
Do not use any insertion tools with cracks. Replace cracked insertion tools.
4
Repairs are not permitted.
Clean grease, oil and water off of the clamping surfaces.
5
Do not use any loose reducing rings or bushes for the reducing of holes on
6
saw blades.
Make sure that fixed reducer rings for securing the insertion tool have the
7
same diameter and have at least 1/3 of the cutting diameter.
Make sure that fixed reducer rings are parallel to each other.
8
Handle insertion tool with caution. They are ideally stored in the original pack-
9
age or special containers. Wear protective gloves in order to improve grip and
to further reduce the risk of injury.
AFTER SALES SUPPORT

1300 855 831
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
Safety regulations

support@scheppach.com.au
MODEL: HM80L PRODUCT CODE: 60120 04/2018
AUS
15