Table of Contents
Advertisement
MOUNTING OVEN TO THE WALL
Two people are recommended to attach the Microwave
Oven/Hood to the Mounting Plate.
1. Thread the power supply cord through the hole made
in the bottom of the top cabinet.
2. Install the oven by sliding it onto the arms of the
Mounting Plate. Push it all the way to the wall. See
Figure 18.
3. Tighten two Mounting Screws (D) located in the oven
faceplate. See Figure 18.
For Louver E (some models)
4. Hook the three lower tabs of Louver E into the slits of
the oven faceplate. Then insert three upper tabs of
Louver E into the slits of the oven faceplate. See
Figure 19.
NOTE: The upper middle tab should be inserted
between the oven faceplate and the outercase cabinet.
Or
Louver F (some models)
4. Insert the top tabs of hood Louver F into the 3 openings
on the cavity faceplate holding Louver F at a slightly
outward tilt. Rotate Louver F so the top tabs are posi-
toned in the cavity faceplate openings. Push in the
bottom of Louver F to ensure that the three bottom
clips snap into the cavity faceplate. Check for proper
engagement. See Figure 19.
5. Replace and tighten one screw (A) (removed in Section
7 on page 4) to the outercase cabinet. See Figure 20.
6. Use the two Top Cabinet Screws 3 and two Flat
Washers 4, supplied in the INSTALLATION HARD-
WARE, to attach the unit to the top cabinet. See
Figure 21.
7. (For Vertical Exhaust Only)
Attach the Exhaust Damper Assembly 8 to the fan
cover on the top of the outercase cabinet by sliding it
into the slits in the same direction as the arrow. Use
Tapping Screw 4 X12 mm 7 from the INSTALLATION
HARDWARE and tighten into place. See Figure 21.
8. Make a bundle of the power supply cord and attach
it to the inside of the cabinet using the Power Cord
Hanger 5. See Figure 21.
Figure 21
(D)
Upper Tabs
5
Grommet (for metal
cabinet only)
3
4
7
(D)
Figure 18
Louver (cross section)
Upper Tabs
Lower Tabs
Louver E
Faceplate
Lower Tabs
Figure 19
(A )
Figure 20
Louver F
Clearance
7
8
Advertisement
Table of Contents
