Table of Contents
Advertisement
Be sure to connect the AC adapter. If the battery power becomes
significantly low, the installation process will be canceled.
4.
Turn on the computer. When the message <F2> to enter System Configuration
Utility appears on the bottom left of the screen, press F2. Then, the Setup Utility
will open.
5.
In the Exit menu, select Load Setup Defaults; then, press Enter twice.
6.
In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter
twice.
7.
The system will restart. When the message Press F10 to Recover appears on the
upper left of the screen, press F10.
The message stays there for two seconds.
8.
Read the message on the screen, and select the way to recover your system; then,
press Enter.
9.
Read the message and select Continue; then, press Enter. The formatting and re-
installation will start.
Although the pointer may be shown on the screen, never touch the
keyboard or the mouse during recovery except when the message prompts
you to. If you touch them, the re-installation will be canceled.
10. When the hard disk has been recovered successfully, the system will restart
automatically.
11. Set up Windows XP by following the on-screen instructions. After you complete
the Windows setup, be sure to set date and time.
Via Recovery CD
Recovery CDs do not come with the computer. First, you need to copy the recovery
data onto CD-Rs and then, recover the system with them.
A-18
Advertisement
Table of Contents
