Status Indicators; Displaying Total Number Of Copies - Sharp AL-1000 Operation Manual

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring to both
the table below and the relevant page.
Indication
Drum replacement
required indicator
TD cartridge
replacement
required indicator
Misfeed indicator
"CH" is blinking in the display.
"CH" is steadily lit in the
display.
"P" is blinking in the display.
A letter and a number appear
alternately.

DISPLAYING TOTAL NUMBER OF COPIES

Use the following procedure to display the total number of copies.
Press the clear (
1
Press and hold down the clear (
2
number of copies will appear in two steps, each with three digits.
Example: Total number of copies is 1,234.
Cause and remedy
Steadily Replacement of drum cartridge will be needed
lit soon. Prepare a new cartridge.
Drum cartridge must be replaced. Replace it
Blinking
with a new one.
Replacement of TD cartridge will be needed
Steadily
soon. Prepare a new cartridge.
lit
TD cartridge must be replaced. Replace it with
Blinking
a new one.
A misfeed has occurred. Remove the misfed
Blinking
paper referring to the description of "Misfeed
removal."
The TD cartridge is not installed. Check if the
cartridge is installed.
Side cover is open. Close the side cover
securely by pressing the round projections
near the side cover open button.
Paper tray is empty. Load copy paper.
A misfeed has occurred in the paper tray.
Remove the misfed paper.
Paper tray is not securely installed. Push the
tray in securely.
The copier will not function. Turn the power
switch off, remove the power cord from the
outlet, and contact your authorized service
representative.
) key to reset the display to zero.
) key for approximately 5 seconds. The total
See
page:
38
27
38
26
31
26
–
13
6
31
–
–
35