Table of Contents
Advertisement
Work position
•
Hold the product with 2 hands.
•
Hold the product on the right side of your body.
•
Keep the cutting attachment below waist level.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
•
Do an overhaul inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Make sure that all covers, guards, handles
and accessories are correctly attached and not
damaged.
To start the product
1. Put the product in the start position.
2. Push and hold the start button until the green LED
comes on.
3. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
The product has a mode button. Withe the mode button
the operator can limit the maximum speed. The mode
button has 3 speed levels. A lower level increases the
time of operation for the product. The mode button has
3 speed levels. A lower level increases the time of
operation for the product. Use level 1 and level 2 if the
operation does not require full speed/full power. If the
operation condition requires full speed/full power, use
level 3. Do not use a higher level than necessary for the
operation.
12
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on.
2. Push the Mode button again to choose the next
speed level.
Automatic shutdown function
The product has a shutdown function that stops the
product if the product is not used. The green LED for
start/stop indication goes off and the product stops after
180 seconds.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Put the product in the stop position.
3. Push the stop button.
1846 - 003 - 24.02.2023
Advertisement
Table of Contents
