Sfp Transceivers - Fortinet FortiWAN 1000E Quick Start Manual

SFP Transceivers

Caution: SFP
transceivers are
static sensitive
devices. Use
an ESD wrist
strap or similar
grounding device
when handling
transceivers.
Do not install
To install the SFP transceivers
or remove SFP
transceivers while
fiber-optic cables
1. Ensure that you are properly grounded.
are still attached.
2. Remove the caps from the SFP cage sockets on the front
This can cause
panel of the unit.
damage to the
3. Position the SFP transceiver in front of the cage socket
cables, cable
connectors,
opening and ensure that the transceiver is correctly
and the optical
oriented. When the transceiver is correctly oriented, the
interfaces. It may
extraction lever will be level with the socket latch. Note:
also prevent the
SFP cage socket orientation may vary. Ensure that the SFP
transceiver from
transceiver module is correctly oriented each time that you
latching correctly
are inserting a transceiver.
into the socket
connector.
4. Hold the sides of the SFP transceiver and slide it into the
cage socket until it clicks into place.
Installing
Note:
and removing
SFP transceivers
can shorten their
useful life. Do not
install or remove
transceivers more
than is necessary.
12 12
5. Press the transceiver firmly into the cage socket with your
thumb.
6. Verify that the transceiver is latched correctly by grasping
the sides of the transceiver and trying to pull it out without
lowering the extraction lever.
If the transceiver cannot be removed, it is installed and
latched correctly.
If the transceiver can be removed, reinsert it and press
harder with your thumb.
If necessary, repeat this process until the transceiver is
securely latched into the cage socket.
To remove the SFP transceivers
1. Ensure that you are properly grounded.
2. If applicable, disconnect the fiber-optic cable from the
transceiver connector and install a clean dust plug in the
transceiver's optical bores.
3. Pull the extraction lever out and down to eject the
transceiver. If you are unable to use your finger to open the
lever, use a small flat-head screwdriver or other similar tool
to open the lever.
4. Hold the sides of the transceiver and carefully pull it away
from the cage socket.
5. Replace the cap on the SFP cage socket and place the
removed SFP transceiver into an antistatic bag.
Caution: Do not
force the SFP
transceivers into
the cage slots.
If the transceiver
does not easily
slide in and click
into place, it may
not be aligned
correctly or may
be upside down.
If this happens,
remove the SFP
transceiver, realign
it or rotate it and
slide it in again.
Note: Follow
proper fiberoptic
handling
procedures when
installing and
removing
SFP transceivers
to ensure the
devices remain
clean and are not
damaged.
13