Advertisement
LENS REPLACEMENT PROCEDURE
Perform the steps
1
REMOVE THE LENS COVER. (See figure-1.)
1. Turn on the LCD projector.
2. Adjust the lens shift, so that lens is set in
the center.
3. Turn off the LCD projector and disconnect
the power cord from the AC outlet.
4. Remove 4 screws of the lens cover and
remove the lens cover.
2
REMOVE THE LENS. (See figure-2.)
1. Remove
the
"K16B" of the circuit board.
2. Loosen the A, B wire bands,
wire holder and remove the
lens motor lead.
3. Remove screws D(4 screws)
which fastens the lens and
remove the lens.
1
to
5
for lens replacement.
connector
Figure shown inside of the cabinet.
(D)
A
(D)
WIRE HOLDER
LENS
MOTOR LEAD
CONNECTOR " K16B "
LENS COVER
Fig-1
LENS MOTOR
(D)
(D)
B
This part wiring should
not be tightened.
Fig-2
Advertisement
