Advertisement
14
Turn the power on.
When the power is turned on, the printer starts the initial setup operation.
When the status lamp is blinking, the printer is preparing to print. It will last approximately
25 min.
Note
• The Initial setup operation is required to prepare the printer for printing. In the initial setup
operation, ink is consumed.
Important
• When the ink warning lamp turns on, replace the lit ink tank color with a new ink tank. There is
insufficient ink required for the initial setup operation. After replacing the ink tank and closing the
ink tank door, the initial setup operation is started.
• When the status lamp is blinking, the printer is preparing to print. Until the status lamp has gone
from blinking to lit, adhere to the follow precautions.
- Do not turn off the printer.
- Do not open/close the maintenance cartridge door or ink tank door.
- Do not operate any other printer components.
• If you turn off the power or open the door during the initial setup operation, the initial setup
operation will be interrupted. In this case, you will need to redo the initial setup operation again.
• Should the printer be unexpectedly operated, the initial set up operation interrupts. When the
initial setup operation interrupts, take the following procedure:
）
1
If the printer has been turned off, turn it on again.
If the ink tank door or the maintenance cartridge door has been opened, close it.
）
2
When the ink warning lamp turns on, replace the lit ink tank color with a new ink tank.
32
4Y8-8175-030
Advertisement
