Advertisement
Troubleshooting
If you have any problems on this product or the printer when in use, please check the following
point first.
If a problem cannot be solved by taking actions described below, disconnect this product from the
printer and contact the dealer or an authorised TOSHIBA TEC service representative for
assistance
Symptom
The charge status mark does not
light even if the adapter is
connected to a Dc Input
The CHARGE lamp on the printer
does not light up.
Specifications
Model:
Connectable device:
Input/output voltage and current:
Operating temperature:
Operating humidity:
Storage temperature:
Storage humidity:
Cord length:
Dimensions:
Weight:
Accessories:
NOTE: Design and specifications are subject to change without notice.
The DC plug is not fully inserted into the DC power source
socket.
Fully insert the plug into the socket.
The DC input is not supplied with the electricity.
Check DC input.
The DC Input is not connected to the printer.
Firmly connect the DC Input to the printer.
The battery pack is not loaded in the printer.
Load a battery pack in the printer.
A fully charged battery pack is in the printer.
The CHARGE lamp does not light up if the battery pack
is already fully charged.
The ambient temperature does not fall within the range
from 0ºC to 40ºC.
The battery is not charged when the ambient
temperature is out of the operating temperature.
B-FP800-DCJA-QM-R
B-FP3D series portable printer
NOTE: This product can only be used on the B-FP3D series.
DC 12-19.5V Max 2.00-2.63A
(Use with 5.5mm (-) / 2.5mm (+) diameter DC Jack.)
Length: 12 mm
NOTE: Only use to DC 12-19.5V specification.
0ºC to 40ºC (32ºF to 104ºF)
10 to 90% (No condensation)
-20ºC to 70ºC (-4ºF to 153ºF)
10 to 90% (No condensation)
Approx. 100 mm
Use with 5.5mm (-) / 2.5mm (+) diameter DC Jack.
Length: 12 mm
Outside
Minus (-)
Approx. 10 g (0.35 oz)
Owner's Manual x 1
7
Cause and resolution
Inside
Plus (+)
Advertisement
