Restarting The Earbuds; Coupling The Earbuds; Removing The Battery - Samsung SM-R190 User Manual

Appendix

Restarting the earbuds

If the earbuds' touch feature becomes unresponsive or the earbuds do not work properly,
restart the earbuds.
To restart the earbuds, insert the earbuds into their corresponding slots in the charging case
and remove them after seven seconds or more.
If the charging case has low battery, connect the charging case to the charger first.

Coupling the earbuds

If you lose one of the earbuds, you do not have to purchase a new set of earbuds because you
can purchase a new earbud and use it with the earbud that you still have.
1
Check the direction of each earbud, the newly purchased earbud and previously used
earbud, and correctly insert them into their corresponding slots in the charging case.
2
Touch and hold both earbuds for seven seconds or more.
The earbud battery indicator light will flash green and turn off to indicate the earbuds are
coupled.
The earbud battery indicator light will keep flashing red when the earbuds are not
coupled properly. Remove the earbuds from the charging case and insert them again.
Then, touch and hold both earbuds for seven seconds or more.
3
Connect the earbuds to a mobile device. For more information, refer to
earbuds to a mobile

Removing the battery

• To remove the battery, contact an authorized service centre.
• For your safety, you must not attempt to remove the battery. If the battery is not
properly removed, it may lead to damage to the battery and device, cause personal
injury, and/or result in the device being unsafe.
• Samsung does not accept liability for any damage or loss (whether in contract or tort,
including negligence) which may arise from failure to precisely follow these warnings and
instructions, other than death or personal injury caused by Samsung's negligence.
device.
43
Connecting the