Panasonic WH-ADC0509L3E5 Installation Manual page 9

3. Remove the top case from the bottom case.
Bottom
case
4. Remove the wiring between Remote controller
terminal.
Claw
(3 places)
Disconnect the
Remote controller
wiring
Mounting The Remote Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Cut here with
a nipper and
remove the burr
with a fi le.
Connect the remote
control wiring
•
Arrange the wires along
the groove of the case.
Bottom case
(Back side)
Top case
Insert the
driver and
slightly turn.
Flat-blade
screwdriver
1
and Tank Unit
Slide it
downwards
to unhook
Mount the bottom case to
the wall.
Wall to which
the remote
controller is
fi xed
Screw
(fi eld supply)
Remote controller terminal board
Remove the coating. Approx. 6 mm
Top case
(Back side)
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
5. For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Avoid the wire
being caught.
Connect the remote
control wiring
Bottom case
Replace The Remote Controller Cover
•
Replace the existing Remote Controller with Remote Controller
Case 5 to close the hole left after remove the Remote Controller.
1. Refer Section "Remove The Remote Controller From Tank Unit"
for remove Remote Controller.
2. Remove the top case from the bottom case of Remote Controller
Case 5 .
Bottom
case
3. Reverse the steps 1 to 4 of section "Remove The Remote
Controller From Tank Unit" to fi x Remote Controller Case 5 on
Tank Unit.
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
Screws
(fi eld supply)
Remote controller
terminal board
Remove the coating.
Top case
Approx. 6 mm
(Back side)
(Back side)
Make sure the wiring
connection is in the correct
direction.
Remote Controller Case 5
(Optional)
Top case
Insert the
driver and
slightly turn.
Flat-blade
screwdriver
9