BEFORE INSTALLATION ………………………… EN7 HOW TO INSTALL ………………………………… EN8 TEST OPERATION ………………………………… EN11 Thank you for purchasing this Panasonic product. • Please read these instructions carefully in order to use this product correctly and safely. • Before using this product, please give your special attention to the SAFETY PRECAUTIONS.
BEFORE USING ELECTRIC WATER HEATER SAFETY PRECAUTIONS Make sure to follow these instructions In order to prevent accidents or injuries to the user, other people and damage to property, please follow the instructions below. The following indications indicate the degree of damage caused by incorrect operation. Indicates risk of WARNING CAUTION...
Page 3
WARNING Switch off the Miniature Circuit Breaker (MCB) before any service to avoid electric shock hazards. In time of lightning / thunder, switch off the Miniature Circuit Breaker (MCB) in advance to protect the appliance against possible damage. Inspect the built-in ELB (once a month) to avoid a hazard to users such as damage to property, serious injury or death.
PARTS IDENTIFICATION Earth Parts not included Flexible Cord (Not included) ON/OFF DP (Double Pole) Switch Front Plate Miniature Circuit Breaker (MCB) ELB Test Button Filter Body Assembly ELB Lamp O Ring ELB Test Temperature Control Knob ELB Reset Lever ELB Reset Push Up Filter Unit FILTER...
HOW TO USE ELECTRIC WATER HEATER Note: • The water temperature lowers as the volume of water is increased by opening the Faucet and water temperature rises as the volume of water is decreased by closing the Faucet. • In case of continuous usage at high temperature setting, water temperature will increase and may cause the control device to activate temporarily resulting in water temperature to drop.
2. Main body cleaning. Be sure to switch off the Miniature Circuit Breaker (MCB) beforehand. • Clean it with moist cloth. • Never use benzene, thinner, detergent, bleach and such for cleaning purpose. • Do not spray water to the appliance, nor put wet towels on it. •...
HOW TO INSTALL ELECTRIC WATER HEATER For Installer WARNING Do not install, remove or reinstall the appliance by yourself. • Improper installation will cause leakage, electric shock, fi re or injury. Installation and wiring must be done by competent personnel. Do not share the inlet and outlet pipe of the appliance with other outlets.
HOW TO INSTALL Note: • During installation process, make sure electrical and water supplies are turned off. 1. Where to install the appliance. • Install the appliance in indoor with frost-free weather proof locations only. Be sure to install the appliance on the wall as illustrated in WARNING Figure 1 (vertical position with the inlet pipe and outlet pipe pointing downward).
Page 9
Note: • For same level holes, use suitable tool to ensure the hole levelness. 25 mm Make 4 holes for Wall Hook at the wall by means of Wall Plug a drill. Drive the Wall Plug into each hole. Ø6 mm Insert the Flexible Cord to the appliance through Figure 3 as shown below: •...
Page 10
Unscrew the cord holder and fi x the cable. Strip the cable (coating). Loosen the screw and fasten the live wire (L) and neutral wire (N) to the ELB (L,N); insert the earth wire under the Earth Plate to the Ground Point with 1 N.m (10 k f.cm) torque.
Main Body (1) Tee joint must be installed between the Main Water Valve and Flexible Pipe. (2) Place Rubber Packing between Filter Body Assembly and Flexible Pipe. Do not use Piping Tape. Tighten it by ELB Reset FILTER CLEANING Lever spanner fi...