Table of Contents
Advertisement
Drive system
5.
Remove
the
two
See Figure 3.16.
Figure 3.16
6.
Remove the caliper and outboard brake puck.
7.
Slide the brake disc off the splined shaft to
expose the inboard brake pad for inspection. See
Figure 3.17.
Brake Disk
Figure 3.17
NOTE: A small amount of good quality lithium
grease should be applied to the splines. Take
care not to get any grease on the brake pads or
the friction surfaces of the rotor.
caliper
mounting
bolts.
Inboard Brake
Pad
8.
Inspect the brake yoke for signs of corrosion that
may prevent proper movement of pins through
the yoke. See Figure 3.18.
Actuator Pins
Brake Pad
Plate
NOTE: The two screws that fasten the brake
yoke have a patch of loctite. Replace them or
apply a small amount of releasable threadlock-
ing compound such as Loctite® 242 (blue)
.
11
Adjustment
Screw
Brake Yoke
Front Brake
Figure 3.18
Pad
Advertisement
Table of Contents
