Commissioning; Operation; Maintenance And Repair; Cleaning And Care - Bosch Rexroth BODAS DSA/12 Instruction Manual

30/36 BODAS speed sensors | Commissioning
Bosch Rexroth AG, RE 95290-01-B/2021-09-13

8 Commissioning

During all work for commissioning the speed sensor, observe the general
safety instructions and intended use detailed in chapter 2 "Safety instructions"
from page 8 on.
▶ When commissioning the sensor, the machine may pose unforeseen hazards.
Before commissioning the system, you must therefore ensure that the vehicle
and the hydraulic system are in a safe condition.
▶ Commission the machine and check the correct functioning of the sensor
(e.g. direction of rotation and rotational speed).

9 Operation

This product is a component which requires no settings or changes during
operation. For this reason, this chapter of the manual does not contain any
information on adjustment options. Use the product only within the performance
range specified in the technical data.

10 Maintenance and repair

10.1 Cleaning and care

Damage to seals and electronics/electrics due to mechanical effects!
A water jet may damage the seals and electronics/electrics of the sensor!
▶ When cleaning with a water jet, the IP protection class must be observed;
depending on this, the water jet may not be directed at the sensor.
For cleaning and care of the sensor, observe the following:
▶ Check whether all the seals and fittings on the plug-in connections are
securely seated to ensure that no moisture can penetrate into the sensor
and the installation space during cleaning.
▶ Use only water and, if necessary, a mild cleaning agent to clean the sensor.
Never use solvents or aggressive cleaning agents.
NOTICE