Table of Contents
Advertisement
Improper cable and line routing!
Risk of stumbling and property damage! Improper routing of cables and lines
can cause a risk of stumbling as well as damage to equipment and components,
e.g. due to lines and connectors being torn off.
▶ Always install cables and lines in a way that nobody can fall over them, that they
are not bend or twisted, do not chafe on edges and are not guided through
ducts with sharp edges without sufficient protection.
Danger due to malfunctions!
Risk of injury and property damage as well as machine damage due to
malfunctions of the sensor!
▶ Carry out a risk assessment of your machine and determine the possible
safety-relevant functions.
▶ Make sure that the expected rotational speed signal (frequency) is provided
with the correct value.
▶ Before operation, check whether the direction of rotation is correctly detected.
▶ Take suitable measures to ensure safety in applications relevant to safety,
e.g. sensor redundancy, plausibility check, emergency switch, etc.
▶ Product data that is required for the safety assessment of the machine is
included in data sheet 95126 (DSA/20),95131 (DST/10), 95132 (DSM/10),
95133 (DSA/12), 95135 (HDD/20) and 95136 (DSM/20).
2.7 Personal protective equipment
The personal protective equipment is the responsibility of the user of the product.
Observe the safety regulations in your country.
All pieces of personal protective equipment should be intact.
Safety instructions | BODAS speed sensors
CAUTION
RE 95290-01-B/2021-09-13, Bosch Rexroth AG
13/36
Advertisement
Table of Contents
