Bosch Active Line Original Operating Instructions page 111

English – 2
display mount (1) from below using the screws (11). When
doing so, be aware of the torque specified on the adapter
tray (2).
Connect the connection cables (10) that come out of the
drive unit and the control unit. It does not matter which
cable is connected to which connection for the functions to
work. When connecting the cables, ensure that the markings
on the connector and on the cable match.
Securing on the handlebars (see figure C)
Note: The display holder must only be secured in the cyl-
indrical area of the handlebars and not in the tapered area.
To align an on-board computer in the centre, the handlebars
must have a cylindrical area of at least 90 mm in width.
Open the clamp and bring the 1-arm socket (6), together
with the round rubber spacer (5), into the required position.
Gently tighten the clamp screw (4) so that the 1-arm
socket (6) can still move.
Adjust the tilt for the display mount by loosening and tight-
ening the screw (7). Ideally, the inclination should be adjus-
ted without the on-board computer.
In the connection between the 1-arm socket (6) and the ad-
apter tray, there are interlocking teeth, which means that it
is only possible to align the adapter tray in predefined posi-
tions. Before tightening the screw (7), make sure that the
teeth engage in one another correctly. In addition, be aware
of the torque specified on the 1-arm socket (6).
Bring the 1-arm socket (6) into its final position and tighten
the clamp screw (4). Be aware of the torque specified on the
1-arm socket (6) here too.
Thanks to the round rubber spacer (5), it is possible to move
the 1-arm socket (6) in all directions.
Removal blocker
A device attached to the display holder can be secured using
the removal blocker (8). Usage is described in the operating
instructions for the respective device.
Maintenance and servicing
Maintenance and cleaning
The display holder must not be cleaned with pressurised wa-
ter.
Use a soft cloth dampened only with water for cleaning. Do
not use cleaning products of any kind.
Have all repairs performed only by an authorised bike
u
dealer.
After-sales service and advice on using products
If you have any questions about the eBike and its compon-
ents, contact an authorised bicycle dealer.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com.
0 275 007 3S1 | (13.02.2023)
Disposal and substances in products
You can find information about substances in products at the
following link:
www.bosch-ebike.com/en/material-compliance.
Do not dispose of eBikes and their components with house-
hold waste.
The drive unit, on-board computer incl. operat-
ing unit, eBike battery, speed sensor, accessor-
ies and packaging should be disposed of in an
environmentally correct manner.
Check that your personal data has been deleted from the
device.
Batteries that can be removed from the power tool without
destruction must be removed before disposal itself and sor-
ted for separate battery collection.
In accordance with Directive 2012/19/EU
and Directive 2006/66/EC respectively, elec-
tronic devices that are no longer usable and de-
fective/drained batteries must be collected
separately and recycled in an environmentally
friendly manner.
Electrical and electronic equipment are collected separately
for pre-sorting by type and helps to ensure that raw materi-
als are treated and recovered properly, thereby protecting
people and the environment.
Please return Bosch eBike components that are no longer
usable free of charge to an authorised bicycle dealer or to a
recycling facility.
Subject to change without notice.
109
Bosch eBike Systems