Introduction; Getting Started; What's In The Box; Choosing A Location - NAD C399 Owner's Manual

WHAT'S IN THE BOX

Packed with your C 389 you will find
•
Two detachable mains power cord
•
SR 10 remote control with 2 AA batteries
•
Bluetooth antennas
•
Quick Setup Guide
SAVE THE PACKAGING
Please save the box and all of the packaging in which your C 389 arrived.
Should you move or need to transport your C 389, this is the safest
container in which to do so. We've seen too many otherwise perfect
components damaged in transit for lack of a proper shipping carton so,
please: Save that box!

CHOOSING A LOCATION

Choose a location that is well ventilated (with at least several inches to
both sides and behind), and that will provide a clear line of sight, within
25 feet / 8 meters, between the C 389's front panel and your primary
listening/viewing position—this will ensure reliable infrared remote control
communications. The C 389 generates a modest amount of heat, but
nothing that should trouble adjacent components.

RESTORING C 389 TO FACTORY DEFAULT SETTINGS

Press and hold both front panel's a SOURCE s buttons until the display
shows the following two reset options. Use a or s buttons to select
through the options.
• Factory Reset MCU? : Restore MCU factory default settings only
• Factory Reset BluOS? : Restore BluOS factory default settings only.
This option is available only if the optional MDC2 BluOS D is installed.
Press [ENTER] to select "Yes" and initiate selected Factory Reset option.
IMPORTANT
Restoring C 389 to factory default settings will delete all applicable
configured or saved settings.

FORCE FACTORY RESET

1 Switch OFF rear panel POWER switch. Leave the unit powered down for
at least 5 seconds.
2 Press and hold rear panel RESET button and then switch ON the rear
panel POWER switch.
3 Continue hold of the rear panel RESET button. Front panel display will
show
SERVICE MODE
PLEASE WAIT
4 Do not release hold of the rear panel RESET button. Continue hold of
the rear panel RESET button until front panel display changes to show
SERVICE MODE
PERFORMING FACTORY RESET
Release hold of the rear panel RESET button.
5 Unit will reboot and stay in Standby mode (amber). Unit is restored to
factory default settings.
NOTE
Force factory reset does not include resetting the MDC2 BluOS D card if
installed.

INTRODUCTION

GETTING STARTED

5