Husqvarna AUTOMOWER 430X Operator's Manual page 30

the product moves in the direction of the charging
station, it always moves to the left of the guide
wire.
The corridor width is adjusted automatically. Only
in rare occasions manual settings need to be
entered. The corridor width can be set between
0-9. If guide corridor width is set to 0, the product
runs over the guide wire. The factory setting is 6
for the boundary wire and 9 for the guide wire.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Corridor width .
3. Use the arrow buttons to select a corridor.
4. Use the number buttons to select a corridor
width of 0-9.
Note: Make the corridor width as wide as
possible for a minimum risk of lines in the lawn.
Exit angles
In the factory setting the product leaves the
charging station in a direction in the 90°-270° exit
sector. Change the exit angles to make it easier
for the product to find the work areas.
If the charging station is put in a passage, 2 exit
angles, for example 70°-110° and 250°-290°, can
be used.
When 2 exit angles are used, it is necessary to
set how frequently the product must leave the
Sector 1 . Use the Proportion
charging station in
function to set how frequently the product must
use each sector. Set in %.
For example 75% means that the product leaves
Sector 1 on 75% of the
the charging station in
times and 25% of the times in
30 - Installation
To set the exit angles
The product moves away from the charging
station with an exit angle between 90°–270°. The
exit angles can be set to 1–2 exit sectors.
1.
2.
3.
4.
5.
6.
To set the reversing distance
The reversing distance is how many cm the
product reverses when it leaves the charging
station. The factory setting is 60 cm.
1.
2.
Installation
3.
4.
To set the Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 31 cm. You can select a
distance of 20-50 cm.
1.
2.
3.
4.
3.10.8 Settings
Sector 2 .
Do steps 1–3 in To get access to the menu
on page 24 .
Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Exit angles > Sector 1 or 2 .
Use the number buttons to set the angles in
degrees.
Push the down arrow button.
Use the number buttons to select how
frequently the product must use each sector.
Set in %.
Push the BACK button.
To get access to the menu
Do steps 1-3 in
on page 24 .
Use the arrow button and the OK button to
move through the menu structure
> Advanced > Reversing distance .
Use the number buttons to set the reverse
distance in cm.
Push the BACK button.
To get access to the menu
Do steps 1–3 in
on page 24 .
Use the arrow button and the OK button to
move through the menu structure
> Advanced > Drive Past Wire .
Use the number buttons to set the distance
in cm.
Push the BACK button.
1201 - 001 - 05.06.2019
Installation
Installation
Installation