Table of Contents
Advertisement
INSTRUCTIONS FOR TYPE A TRACTORS
STEP 1:
(SEE FIGURE 5)
•
Remove any bolts found in the holes indicated in the
illustration.
REMOVE BOLTS FROM THESE HOLES
FIGURE 5
STEP 2: (SEE FIGURE 6)
•
Attach the R.H. hanger bracket to the two front empty
holes on the right side of the tractor frame using two
new 3/8" x 1" hex bolts (D), 3/8" lock washers (R),
and 3/8" flat washers (O) as shown. For the rear hole,
use a 3/8" x 1" hex bolt (D), 3/8" lock washer (R)
and 3/8" flat washer (O) with a large 1/2" washer (N)
placed between the hanger bracket and the tractor
frame. Tighten. Repeat for the left side.
•
Go to page 8 "INSTRUCTIONS FOR 917 MODEL
TRACTORS".
3/8" FLAT
WASHER (O)
3/8" LOCK
WASHER (R)
3/8" x 1"
HEX BOLT (D)
R.H. HANGER
BRACKET
FIGURE 6
FRONT
SUSPENSION
BRACKET
1/2" LARGE
WASHER (N)
INSTRUCTIONS FOR TYPE B TRACTORS
STEP 1: (SEE FIGURE 7)
•
Remove any bolts found in the holes indicated in the
illustration.
REMOVE BOLTS FROM
THESE HOLES
FIGURE 7
STEP 2: (SEE FIGURE 8)
•
Attach the R.H. hanger bracket to the three holes
shown on the side of the tractor frame using three
3/8" x 1" hex bolts (D), 3/8" lock washers (R), 3/8"
flat washers (O) and 1/2" large washers (N). Use 3/8"
nylock nuts (M) on inside of frame if bolts insert freely
into holes. Tighten.
•
Repeat for other side.
Go to page 8 "INSTRUCTIONS FOR 917 MODEL
•
TRACTORS".
NOTE: Use special 3/8" x 1" thread forming bolts (G) in any
holes that are too small for regular bolts.
3/8" x 1" HEX BOLT (D)
(OR THREAD FORMING
BOLT (G) IF NEEDED)
3/8" LOCK
WASHER (R)
3/8" FLAT
WASHER (O)
R.H. HANGER
BRACKET
FIGURE 8
7
FRONT
SUSPENSION
BRACKET
3/8" NYLOCK NUT (M)
(IF NEEDED)
1/2" LARGE
WASHER (N)
Advertisement
Table of Contents
