Table of Contents
Advertisement
INSTRUCTIONS FOR TRACTORS WITH SINGLE
FRONT DECK SUSPENSION BRACKET
STEP 1: (SEE FIGURE 2)
•
Remove the tractor hood. Refer to your tractor owners
manual for instructions on how to properly remove the
hood.
•
Remove the browning shield from the front of the
tractor as shown. Hold onto the shield as you remove
the second bolt to prevent it from falling.
NOTE: Reinstall browning shield before using tractor.
FIGURE 2
STEP 2: (SEE FIGURE 3)
•
Fasten the R.H. Side Plate (bend facing out) to the
front three holes in the tractor frame using three 3/8"
x 1" carriage bolts (H), three large 1/2" washers (N)
(see note) and three 3/8" nylock nuts (M). For the
rear hole, use a 5/16" x 1" carriage bolt (F), a large
1/2" washer (N) and a 5/16" nylock nut (L). Place the
washers between the tractor frame and the side plate.
Tighten all bolts. Repeat for L.H. side plate.
NOTE: If there is an engine mounting plate (shown with
dotted lines) leave the large 1/2" washer (N) off the
bolt that goes through the plate.
•
Reinstall the browning shield removed in figure 2.
•
Go to page 8 "INSTRUCTIONS FOR 917 MODEL
TRACTORS".
5/16" x 1" CARRIAGE
BOLT (F)
(SEE NOTE)
5/16" NYLOCK
NUT (L)
3/8" NYLOCK
NUT (M)
FIGURE 3
REMOVE
BROWNING
SHIELD
ENGINE
MOUNTING
PLATE
1/2" LARGE
WASHER (N)
3/8" x 1" CARRIAGE
BOLT (H)
INSTRUCTIONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSION BRACKETS
IDENTIFY YOUR SUSPENSION BRACKETS
•
Compare your tractor to the ones shown in figure 4.
•
If your tractor resembles the top illustration, go to
page 7 "INSTRUCTIONS FOR TYPE A TRACTORS".
•
If your tractor resembles the bottom illustration, go to
page 7 "INSTRUCTIONS FOR TYPE B TRACTORS".
TYPE A
TYPE B
FIGURE 4
6
FRONT SUSPENSION
BRACKET
FRONT SUSPENSION
BRACKET
Advertisement
Table of Contents
