Warranty; Fcc Compliance - Hitachi E-Compact High Power Series Operation Manual

2. Warranty

1. All equipment shall have warranty coverage by the supplier against manufacturing or assembly faults conducted by the
supplier for the period of 12 months, beginning upon the issuing of the sales invoice. The period is irrevocable except in cases
of extended warranty previously noted in the contract.
2. During warranty time, the supplier will repair, with no additional charge, the faulty products, providing adjustments, replacing
or re-manufacturing all the equipment or its modules and components that present unusual behavior;
2.1. The repaired/replaced products are covered for an additional period of 3 (three) months or up to the end of the original
warranty time, taking into count the longer period;
2.2. If the additional 3 (three) months term, referred above, is higher than the original warranty term, the warranty will only
extend to the repaired/replaced modules or components;
2.3. The warranty will become effective in the supplier's factory; therefore, it is not a responsibility of the supplier: the
shipment of any modules, components or any other equipment or accessory. These expenses will be, when due, a responsibility
of the Purchaser.
2.4. The Purchaser may choose to have the supplier's technical personnel travel to the Purchaser's location, instead of
submitting the goods for factory repair, although the expenses relative to transportation, lodge and nourishment of the supplier's
technicians will occur at sole expense of the Purchaser, upon budget approval.
3. The supplier is relieved of the warranty terms in the hereinafter situations:
3.1. Faults or defects caused by AC Mains variation, atmospheric phenomena or accidental;
3.2. Faults or defects caused by inadequate installation of the goods, not complying with the OPERATING MANUAL(S) or
by negligence of the minimum infrastructure requirements in the installation site, which is referred in the ANNEX 1 herein
attached.
3.3. Faults or defects caused by inadequate usage of the products, not complying with the OPERATING MANUAL(S) or by
lack of proper preventive maintenance recommended in the product's manual.
3.4. In event of the goods and its accessories are submitted to 3
as removal or violation of its serial number.
4. The supplier shall employ, during warranty term, original parts and components listed by the product's manufacturer.
5. The technical assistance must be held by the SUPPLIER or its accredited personnel or companies, failing which will result in
warranty voidance.

2.1. FCC Compliance

This equipment has been tested and found to comply with the limits for a Class A Digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense. The antenna(s) used for this transmitter
must be fixed-mounted on the outdoor permanent structures. RF exposure compliance is addressed at the time of
licensing, as required by the responsible FCC Bureau(s), including antenna co-location requirements of §1.1307(b)(3).
2. Changes or modifications not expressly approved by Hitachi Kokusai Electric Comark LLC could void the user's
authority to operate the equipment. 3. This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
rd
Party maintenance, unauthorized by the supplier, as well
E-Compact HP-BB3 Series
12 | 169