Philips ReCare 7.0 U User Manual page 18

The 7.0 U is an easy product to set up and use, from the adjustments to
the intuitive interface. This section explains how to set up, adjust and
operate your 7.0 U.
Leveling the 7.0 U
Once the 7.0 U is assembled, and placed on a at level oor, it may
be necessary to adjust the four leveling glides on the bottom of the
rear incline unit to ensure proper stability of the 7.0 U. Use a 1/2"
wrench to loosen the top nut of the leveler. Adjust the levelers by
hand as necessary to remove any wobble in the unit. Then tighten the
top nut against the bottom of the stabilizer tube. Make sure the
bottom nut remains cinched against the leveling foot.
Connecting to A.C. power
The 7.0 U has a built-in universal power supply. You can plug the 7.0
U into any A.C. power source from 90 to 240 volts, 50 to 60 Hz. The
A.C. input is located in the front of the unit. The input module has an
input connector for the line cord, a power switch and a 5 amp fuse.
Turn the power switch to o when the 7.0 U is not in use.
Adjusting the seat vertical position
To raise the seat position, loosen the knob one or two turns and lift
up from under the rear of the seat. The Knob has a spring loaded pin
that will automatically seat in the slots in the seat post at each posi-
tion. Once the seat is at the desired setting, tighten the knob to
ensure the seat post won't accidentally slide downward during use.
To lower the seat, loosen the knob then hold under the rear of the
seat and pull the knob out to disengage the pin from the seat post.
You can then lower the seat position to just below the desired setting
then release the knob and pull the seat up until the pin clicks into
place and tighten the knob. There is a numbered scale located on the
seat post, under the seat, for repeatable settings.
Adjusting the seat fore/aft position
Loosen the knob and slide the seat to the desired position. There is a
numbered scale located on the seat slide, under the rear of the seat,
for repeatable settings.
18