How To Operate The Timer - Sharp DW-208EX Operation Manual

How to Operate the Timer

How to Operate the Timer
To set on timer
(Example of indication)
DEHUMID SETTINGS button
Pip
DEHUMID
SETTINGS
1
Press timer setting button.
When you note that the "ON" on the liquid crystal indicator starts to blink this indicates that the timer has
been set "ON" after 1 hour.
Select set-time of TIMER since the indication shifts at an hour intervals by pressing Timer setting button
as follows:
The indication will continue to shift automatically by pressing the Timer setting button.
2
Press DEHUMID SETTINGS button or DRY CLOTHES SETTINGS button.
Press DEHUMID SETTINGS button when you select DEHUMID operation mode other than "AUTO DRY".
(The AUTO DRY is indicated as " mark" on the operation mode.)
In case of DEHUMID operation mode, it is possible to operate by "Fan speed/LOW, ON/OFF" or "Fan
speed LOW, ON/ OFF". Select and press either of them.
Press DRY CLOTHES SETTINGS button when you select a DRY CLOTHES mode other than
"STANDARD".
(STANDARD is indicated as " mark" on the operation mode.)
3 Press Power ON/OFF button.
The operation indicator will stop blinking when the Power ON/OFF button is pressed, and the ON TIMER
operation will be enabled or set. "ON" on the liquid-crystal indicator shifts from blinking into lighting.
The TIMER indicator figure will decrease sequentially by "1" following each 1 hour lapse after the
TIMER was set.
(Example) shifts to 8 hours after 9 hours.
Example
Attention
How to cancel ON TIMER operation
Press the power ON/OFF button.
Operation indicator, "
part, and " mark" on operation mode indicator are all turned off. Then
ON TIMER operation is released.
14
(it can be set only when the unit is shut down.)
Standard operation of clothes drying mode
Display of ON TIMER after 5 hours
AUTO DRY
ROOM DRY
CONTINUOUS
DRY
Lighting→Blinking
CLEAN AIR
2
HIGH LOW
FAN SPEED
If you set ON TIMER operation as "after 5 hours,"
Dispose of water in the tank, since the ON TIMER operation cannot be set when the
Full tank lamp or Full tank indicator is on.
It is possible to shift from "DEHUMID SETTINGS" or "DRY CLOTHES" operation
mode after the ON TIMER operation is set. Change it by pressing either of the button.
You cannot change the starting time of operation after the ON TIMER operation has
been set. To reset, you need to cancel ON TIMER operation.
TIMER", "ON after
ON / OFF
3
Operation indicator
You will hear beeping sounds for about one minute after
(
pressing the key for about 5 seconds.
No indication
hours" on the liquid-crystal
DRY CLOTHES SETTINGS
button
Pip
FAST
STANDARD
DRY CLOTHES
SETTINGS
GENTLE
Lighting
Timer setting
button
(set release)
The operation starts after 5 hours.
(Example of indication): indicating
state of ON TIMER operation re-
lease
2
1
)