Table of Contents
Advertisement
STEP 4 Initial settings
By completing the following steps, the wine cellar should be fully functioning.
1. Remove the PE foam sheet on each shelf corner, which is attached to protect the wine
cellar during transportation.
2. Plug the power cord into the wall socket to turn the wine cellar on.
3. Open the door, and check if the interior light lights up.
4. Set the temperature to the coldest available, and wait for about an hour. Then, the wine
cellar will be slightly chilled with the motor running smoothly.
5. Wait until the wine cellar reaches the set temperature. Now the wine cellar is ready for
use.
STEP 5 Final check
When the installation is complete, confirm that:
• The wine cellar is plugged into an electrical outlet and grounded properly.
• The wine cellar is installed on a flat, level surface with a reasonable clearance from the
wall or the cabinet.
• The wine cellar is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when you
open the door.
Untitled-8 29
To adjust the height of the right side:
Insert a flat-head screwdriver into the
leveller of the front right leg. Turn the
leveller clockwise to raise, or turn it
anticlockwise to lower.
English
29
2022-10-20
4:22:09
Advertisement
Table of Contents
