Table of Contents
Advertisement
Chapter 2 Preparations
4.
Slide the battery bracket with the battery attached back into the server.
Connecting to a RAID controller
1.
Connect another connector of the flash backup unit control cable to the connector on the RAID
controller. Check the form of the connector and connect the cable straight into the connector. Be
careful not to press it in at an angle when connecting.
Position of the connector
Connect the cable to the connector shown in the figure below.
Important
Make sure that the battery bracket is correctly attached to the server.
Connector for battery cable
Rear face of RAID controller
Express5800/T110g-E User's Guide
1. Installing Internal Optional Devices
63
Advertisement
Table of Contents
