Polaris RZR XP 1000 EPS Owner's Manual page 29

FEATURES AND CONTROLS
Switches
Headlight Switch
Use the headlight switch to turn the lights on and
HIGH
off and to change the lights from high beam to low
beam. The ignition switch must be in the ON
position to operate the headlights.
LOW
Press the top of the rocker switch toward the dash
to place the headlights on high beam. Move the
rocker switch to the center position to place the
headlights on low beam. Press the bottom of the
rocker switch to turn off the headlights.
If the headlight switch is ON when the ignition
switch is turned off, the lights will remain on for
AWD
approximately 20 seconds.
All Wheel Drive (AWD) Switch
The AWD Switch has two positions:
2WD
• All Wheel Drive (AWD)
• Two Wheel Drive (2WD).
Press the top of the rocker switch to engage All
Wheel Drive. Press the bottom of the switch to
operate in two wheel drive.
See page 38 for AWD operating instructions.
Electronic Power Steering (EPS)
Electronic power steering (if equipped) engages when the ignition key is
turned to the ON position. EPS remains engaged whether the vehicle is
moving or idle.
The EPS warning indicator briefly illuminates when the key is turned to
the ON position. See page 40.
To conserve battery power, the EPS will shut down 5 minutes after the
engine is stopped if the key remains in the ON position. The EPS
warning indicator will illuminate to indicate the EPS has shut down.
If the light remains on after starting the engine, the EPS system is
inoperative. Your POLARIS dealer can assist.
27