GE 106727 Owner's Manual page 17

How T o Maintain
E. How t o Replace t he Carpet
Sham pooer/Ext ract or's Belt
NOTE:
Turn off the power switch and unplug the electrical cord
to replace the brush roll belt.
NOTE: If the tanks contain liquid, remove both tanks before
placing the handle on the floor.
FIGU RE 2
FIGU RE 3
* When reinstalling the brush roll, check the end caps for correct alignment into the base of the unit. Sometimes
th e squares of the end caps become off-center. By h oldin g on e en d an d turn in g th e oth er, realign men t can
be corrected.
1. Tip th e carpet sh ampooer/ extractor back to place th e
Belt
Cap
2. Position yourself in fron t of th e carpet sh ampooer/
3. Lift off th e belt cap.
4. Lift brush roll out an d remove worn belt.
5. Squeeze th e sides of n ew belt togeth er an d place it
6. Place th e pulley en d of brush roll in side th e belt.
7. Align brush roll en d caps with open in gs in base.
8. Push down on th e brush roll to secure it ( Figure 3) .
9. Rotate th e brush roll un til th e belt is in place.
Belt
10. Replace belt cap an d secure with screw.
Brush Roll
End Cap
Belt
Cap
Brush Roll Belt
M otor
Pulley
The brush roll belt on the carpet shampooer/ extractor drives
th e brush to agitate, sweep, an d comb th e carpet n ap. Ch eck
th e belt regularly to be sure it is in good con dition . Replace
th e belt if it is stretch in g, crackin g or slippin g. Cut away an y
h air or th read woun d aroun d th e brush roll or th e belt pulley
because th e buildup could cause th e belt to rotate un even ly.
FIGU RE 1
h an dle on th e floor ( See Figure 1) .
extractor's base an d remove th e screw from th e right
side of base ( Figure 2) .
aroun d th e motor pulley. Squeezin g th e belt will aid in
placin g th e belt on th e pulley.
(for models with a brush roll)
17