GE 106727 Owner's Manual page 16

How T o Maintain
NOTE: Turn off the power switch and unplug the electrical cord to service cleaning nozzles.
C. Cleaning t he Carpet Sham pooer/Ext ract or's Suct ion Cover
D . Cleaning t he Carpet
Sham pooer/Ext ract or's
Plunger, Boot Seal and
Filt er
1. Remove the clean water solution tank.
2. Remove th e Plunger, Boot Seal and Filter
Assembly by lifting up the Boot Seal. This
will pull out th e Plunger, Boot Seal and
Filter Assembly ( see Figure 1) .
3. Remove the Reservoir Filter and clean it
by removin g an y debris and rinsing with
water.
4. Rein sert th e Filter on th e Plun ger stem
and place the Assembly directly into the
reser voir. In stall th is assembly in to th e
reservoir by pressing down on the top of
th e plastic plunger. Do not press down on
th e rubber boot seal.
IM PORTANT! Make sure the plunger stem
is placed into the hole in the
bottom of the reservoir for
a secure fit (see Figure 2).
5. Replace the Clean Water Solution Tank
b a ck o n t o t h e ca r p e t sh a m p o o e r /
extractor unit.
16
Suction
Cover
1. Rem ove th e screws from each
2. Lift th e su ction cover off an d
3. Rep lace th e su ction cover by
Tabs
4. Align on e of th e screw h oles in
Suction Cover Gasket
(around rim of suction
cover area on unit)
FIGU RE 1
Plunger, Boot Seal and
Filt er A ssem bly
side of th e suction cover.
clean the area of dirt an d lin t.
slid in g th e tabs on top of th e
suction cover into the top slots
o n th e h o o d . Make su r e th e
suction cover gasket is in place
o n th e u n it b efo r e r ep lacin g
cover.
th e suction cover, h ood an d base
th e n se cu r e with scr e w. Also
com p lete th is step for secon d
screw h ole.
Boot Seal
Plunger Stem Assembly
Reservoir Filter
FIGU RE 2
Correct installation
of assembly