Table of Contents
Advertisement
1
Safety information
Operating/storage environment
• Do not install or store the device in any of the locations listed below.
Doing so may result in failure or malfunction, device falling, or fire or injury.
Prohibited
– Close to facilities where water is used
– Where it will be exposed to direct sunlight
– Close to the air outlet of an air-conditioner or ventilation equipment
– Close to a heat source such as a heater
– Where the power supply is unstable
– On the floor
– In a dusty environment
– In a saline or sulfurous environment
– Where temperature or humidity is high
– Where there is freezing or condensation
– In areas prone to vibration
– On an incline or in an unstable area
• Use this product in an environment within a temperature range of 5°C
to 35°C.
• When using the detector, if you observe an abnormal rise in temperature
above the temperatures listed below, stop using it immediately.
The maximum temperature of the detector: 45°C*.
* This is measured during maximum load test when the ambient temperature is set to
• Avoid doing the following actions to the detector during exposure
ready status. Otherwise, the detector may acquire an image without
exposure.
– Giving a strong shock and vibration.
– Using the detector in a location where static electricity is easily generated.
– Using the detector in a location where electromagnetic wave noise might be
generated.
• Images may not be acquired because the exposure conditions, such
as X-ray exposure conditions or target body positioning, are not
effective. For details, see "Troubleshooting" (➞ page 39).
10
35°C.
CAUTION
Advertisement
Table of Contents
