Get Started; Charge The Battery; Pair The Earpieces With Your Bluetooth Device For The Rst Time - Philips 2000 Series User Manual

3 Get started

Charge the battery

Note
 Before you use your earpieces for the rst
time, place the earpieces in the charging box
and charge the battery for 2 hours for
optimum battery capacity and lifetime.
 Use only the original USB-C charging cable to
avoid any damage.
 Finish your call before charging the earpieces,
as connecting the earpieces for charging will
power the earpieces o .
Charging
Connect one end of the USB cable into
the charging box, and another end into
the power source.
The charging box starts charging.
• Charging process is veri ed by the
LED light on the front panel.
• When the charging box is fully
charged, the light goes o .
Tip
 The charging box serves as a portable backup
battery for charging the earpieces. When the
charging box is fully charged, it supports 2
times full recharge cycle for the earpieces.
 Normally, a full charge takes 2 hours (for the
earpieces or charging box) by USB cable.
Pair the earpieces with
your Bluetooth device
for the rst time
Make sure that the earpieces are
fully charged.
Open the top cover from charging
box.
The LED on both earpieces
ashes in white & blue alternately.
The earpieces are now in
pairing mode and are ready to
pair with a Bluetooth device
(e.g. a mobile phone)
Turn on the Bluetooth function of
your Bluetooth device.
Pair the earpieces with your
Bluetooth device. Refer to the user
manual of your Bluetooth device.
Note
 After powering on, if the earpieces cannot nd
any previously connected Bluetooth device, it
will automatically switch to pairing mode.