Table of contents
1
1.1
1.2
2
2.1
Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24
2.2
2.3
2.4
Data plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24
2.5
Technical data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
3
Regulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26
4
Transport . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26
5
Mounting method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26
5.1
5.2
5.3
cylinder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
5.4
6
Commissioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
6.1
6.2
7
Decommissioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
8
9
9.1
Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
9.2
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
9.3
9.4
9.5
Function check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
9.6
Stora - 6721847474 (2023/02)
1
Explanation of symbols and safety instructions
1.1
Explanation of symbols
Warnings
In warnings, signal words at the beginning of a warning are used to
indicate the type and seriousness of the ensuing risk if measures for
minimizing danger are not taken.
The following signal words are defined and can be used in this document:
DANGER
DANGER indicates that severe or life-threatening personal injury will
occur.
WARNING
WARNING indicates that severe to life-threatening personal injury may
occur.
CAUTION
CAUTION indicates that minor to medium personal injury may occur.
NOTICE
NOTICE indicates that material damage may occur.
Important information
The info symbol indicates important information where there is no risk to
people or property.
Additional symbols
Symbol
Meaning
▶
a step in an action sequence
a reference to a related part in the document
•
a list entry
-
a list entry (second level)
Table 25
1.2
General safety instructions
HInstallation, commissioning, maintenance
Installation, commissioning and maintenance may be performed only by
an approved contractor.
▶ Install and commission cylinders and their accessories according to
the relevant installation instructions.
▶ To reduce oxygen permeation and therefore corrosion to a minimum,
do not use vapour-permeable components! Never use open, vented
expansion vessels.
▶ Never close the pressure relief valve.
▶ Use only original spare parts.
HNotices for the target group
These installation instructions are intended for gas, plumbing, heating
and electrical contractors. All instructions must be observed. Failure to
comply with instructions may result in material damage and personal
injury, including danger to life.
▶ Read the installation, service and commissioning instructions (heat
source, heating controller, pumps, etc.) before installation.
▶ Observe the safety instructions and warnings.
Table of contents
23