CASIO EDIFICE Standard Chronograph Manual

Table of Contents

Contents

1 Overview
2 To adjust the time setting
3 To change the day indicator setting
4 Crown Operations
5 If your watch has a rotary bezel...
6 Using the Stopwatch
7 Correcting the 0 Positions of the Hands
8 Specifications
9 Documents / Resources
- 9.1 Download manual

Overview

Your watch may differ somewhat from the one shown in the illustration.
Some models may use a combination of hands and rotating disks to indicate information. The word "hand" in this section is used to mean both analog hands and rotating disks.

Overview

To adjust the time setting

When the second hand is at 12 o'clock, pull the out to Click 2.

Rotate the to change the time setting.

Push the back in.
Note

Take care that you set the correct AM or PM time.
When changing the time, move the minute hand four or fi ve minutes past your fi nal setting, and then back it up to the setting you want.

To change the day indicator setting

Pull the out to Click 1.

Rotate the to set the day.

Push the back in.
Note

The day indicator setting uses a 31- day month. Make adjustments for months of shorter lengths.
Avoid changing the day indicator setting between the hours of 9 p.m. and 1 a.m.
Otherwise, the day indicator may not change correctly at midnight.

Crown Operations

Some water-resistant models (100 meters, 200 meters) have a screw-in crown. When you need to perform a crown operation, rotate it towards you to unscrew it. Then pull the crown out. Avoid applying undue force when pulling.
The watch loses its water resistance while the crown is unscrewed. After performing a crown operation, fully screw the crown back in.

If your watch has a rotary bezel...

You can rotate the bezel to align its mark with the minute hand. Then you will be able to tell how much time has elapsed since aligning the mark.
If your watch has a rotary bezel

Using the Stopwatch

The stopwatch measures elapsed time in 1/10-second increments up to 59 minutes, 59.9 seconds.
Using the Stopwatch

Do not operate the stopwatch with the crown pulled out.

Note
An elapsed time operation will stop automatically at the end of 60 minutes.

Correcting the 0 Positions of the Hands

Perform the following procedure if the stopwatch hands do not return to their 0 (zero) positions when you reset the stopwatch.

Pull the out to Click 2.

Press to move the Stopwatch 1/10-Second Hand clockwise.

Holding down will move the hand at high speed.

Press to move the Stopwatch Second Hand clockwise.

Holding down will move the hand at high speed.
The Stopwatch Minute Hand is synchronized with the Stopwatch Second Hand

After all of the hands are the way you want, push the back in.

Timekeeping stops while the crown is pulled out. Correct the current time setting after performing the above operation.

Specifications

Accuracy: ±20 seconds average per month
Stopwatch: Measuring Capacity: 59'59.9" (60 minutes)
Measuring Unit: 1/10 second
Measurements: Elapsed time; split time; two fi nishes
Battery: One silver oxide battery (Type: SR920SW)
Battery Life: Approximately 2 years (60 minutes stopwatch operation per day)