Table of Contents
Advertisement
6. Use the arrow buttons to find the Phonebook entry
you want to assign to the speed dial button and
press
.
Dialling a speed dial entry
1. On the keypad, press and hold the speed dial
number you've assigned your phonebook entry to.
Their phone number will be dialled automatically.
If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
Phonebook
35
- Quick Links:
- Quick Set up Guide
- Handset Display
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the BT3570 and is the answer not in the manual?
Questions and answers
Why do I keep getting a bleeping noise every 10 seconds while the battery is charging for recommended 16 hours
The BT BT3570 may be making a bleeping noise every 10 seconds while charging because the batteries might be low or not properly activated. Ensure the batteries are correctly inserted, charged for the recommended time (16 hours for the first charge), and in good condition. If the issue persists, consider replacing the batteries and ensure the handset is properly placed on the base or charger. For further assistance, you can call 0800 145 6789.
This answer is automatically generated
Why has my phone switched to busy mode
How can I increase volume on speaker
Why when I try to make an outgoing call won’t it call & says busy
The BT3570 may say "busy" when making an outgoing call due to network issues or interference. Check if another call is already in progress on the same line. If the issue persists, contact your network provider or, if you are a BT customer, call 0800 800 151 for support.
This answer is automatically generated
My bt3570 isn’t making outgoing calls just says busy when; I try
Your BT3570 may not be making outgoing calls and is showing a busy signal for the following reasons:
1. The handset may be out of range of the base. Ensure it is within range.
2. Another handset registered to the BT3570 base may already be using the line.
3. The handset might not be properly registered to the base. Check the registration status (see page 55 of the manual).
4. The mains power to the base may not be correctly connected. Verify the power connection.
Try these steps to resolve the issue.
This answer is automatically generated
bought BT3570 call blocking and answer machine followed set up instructions when a message is left and call ended machine keeps recording , when it eventually stops recording and I try to listen to the message a loud alarm type sound emits from the base unit