Operation - Husqvarna 236R Operator's Manual

7. Install the locking pin or hex key (C) in the hole to
lock the shaft.
H
8. Assemble the trimmer head/plastic blades (H). Turn
the trimmer head/plastic blades counterclockwise.
9. To disassemble, follow the instructions in the
opposite sequence.
To install the transport guard
1. Install the blade in the transport guard (A).
2. Put the two fasteners (B) into the slots (C) to attach
the transport guard.
B
A
To install the 2-teeth blade in the guard
1. Install the blade in the transport guard.
WARNING: Read and understand the safety
chapter before you operate the product.
14
H
C

Operation

To adjust the harness
WARNING: The product must always be
correctly attached to the harness. Do not
use a defective harness.
1. Put on the harness.
2. Connect the product to the harness.
3. Adjust the harness for the best work position.
4. Adjust the side straps to make the product weigh
equally on your shoulders.
5. Adjust the harness until the cutting attachment is
parallel to the ground.
6. Let the cutting attachment lightly touch the ground.
Adjust the harness clamp to balance the product
correctly.
Note: If you use a grass blade, it must balance
approximately 10 cm /4 in above the ground.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
1395 - 004 - 14.09.2020